Difference between revisions of "ITrack/Error 1050: Table Already Exists"
From ISoft Wiki
< ITrack
Jump to navigationJump to search
(Clarified a bit) |
(Added to Error Messages category) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 7: | Line 7: | ||
Immediately after the error message is displayed, ITrack should clean up the table for you. Attempting to run the report again should yield appropriate results. | Immediately after the error message is displayed, ITrack should clean up the table for you. Attempting to run the report again should yield appropriate results. | ||
[[Category:Printing | [[Category:ITrack/Problems/Printing]] | ||
[[Category:Error Messages | [[Category:ITrack/Problems/Error Messages]] | ||
Latest revision as of 10:37, 14 July 2009
This error will sometimes appear when attempting to print a report that uses a prequery.
Cause
If this error occurs while attempting to print a report, it happens because the table created the last time the report was run did not get cleaned up correctly.
Solution
Immediately after the error message is displayed, ITrack should clean up the table for you. Attempting to run the report again should yield appropriate results.
